Reverse Polarity Protection Circuit Diagram - Simple Electronic Project

Introduction

content

content

content

Diagram of Reverse Voltage Protector Circuit

Advertisements

Advertisements

Components Needed for this Project:

You can get the components from any of the sites below:

  1. 3.3k Ohm Resistor [See Buy Click Amazon]
  2. 10a10 Diode [See Buy Click Amazon]
  3. LED 5mm [See Buy Click Amazon]
  4. 5A 12v Fuse [See Buy Click Amazon]

*Please note: These are affiliate links. I may make a commission if you buy the components through these links. I would appreciate your support in this way!

Related Basic Electronic Mini Project Circuit Diagram:

Advertisements

Advertisements

Working Principle

content

content

content

Frequently asked questions

What is the reverse polarity of a circuit?

Reverse polarity is a condition where the wires of an outlet are connected in reverse Point. This means that the Line wire and the neutral wire are not connected as they should be. A healthy wiring outlet normally includes 2 sides, or wires, the right side is known as the hot wire.

Is reverse polarity AC or DC?

When the electrode is positive and the plates are negative, this results in direct current reverse polarity. The electrons switch directions and go from the base plates to the electrode.

How does AC reverse direction?

In AC, a rotating coil between 2 magnets changes the direction of the electrons flowing through the coil as it rotates, resulting in an alternating current.

Do MOSFETs allow reverse current?

They do this because they have a parasitic diode between the source and drain called an intrinsic body diode. When learning power electronics. we all discovered that MOSFETs can conduct in reverse Point (because they have a body diode) and IGBTs.

Is an MOSFET limit current?

Most of these ICs on the market use external MOSFETs as switches for switching the current flow on the off side, but also for limiting the current.

Related Articles