Single Phase MCB Connection:

This diagram shows how to make a single-phase MCB connection. In this circuit, we use four SP MCBs ( Single Pole Miniature Circuit Breaker ). Here we need to connect our all MCBs with phase connection and then connect the neutral line to all loads. Now this circuit is ready for use. This circuit is very simple and very easy to make. If you want to know more about this circuit, please check our youtube video below the post.

Diagram of Single Phase MCB Connection:

Components needed For this Project:

You can get the components from any of the sites below:

SP MCB 10A [See Buy Click Amazon]

*Please note: These are affiliate links. I may make a commission if you buy the components through these links. I would appreciate your support in this way!

Read Also:

Components used to make the Single Phase MCB Connection:

01. SP MCB:

In single-pole MCB, Switching and protection are Affected in only one Phase. Single phase supply to break the phase only. A single Pole breaker is Typically used with 120-volt Circuits, and a 6-20 amps Miniature Circuit Breaker. They are constructed with one Line Wire and one Neutral wire. A Single Pole switch is the most basic General-Purpose switch that you use to Control a light or another device from one location. These Switches have 2 Brass-Colored screw Terminals Connected to the hot Power source wires. Pole refers to the number of Circuits Controlled by the Switch SP Switches Control only one Switch Electrical Circuit.

Thank You for visiting the website. Keep visiting for more Updates.

← Previous Next →

Single Phase MCB Connection