Energy Meter Connection:

This diagram shows how to make an energy meter connection. In this circuit, we use a single-phase energy meter, and an SP MCB ( Single Pole Miniature Circuit Breaker ). First, we need to input the power line into the energy meter. Then input power to the circuit breaker then from the breaker to input phase line to home load. Then need input a neutral line to the home. Now this circuit is ready for use. If you want to know more details about this circuit please check our youtube video below the article.

Advertisements

Diagram of Energy Meter Connection:

Energy Meter Connection

Components needed For this Project:

You can get the components from any of the sites below:

  1. Single Phase Energy Meter [See Buy Click Amazon]
  2. SP MCB 25A [See Buy Click Amazon]

*Please note: These are affiliate links. I may make a commission if you buy the components through these links. I would appreciate your support in this way!

Read Also:

Advertisements

Components used to make the Energy Meter Connection:

01. Single Phase Energy Meter:

A Single-Phase Energy Meter is a sort of Watt-Hour meter. It consists of two Electromagnets. Single-Phase Energy Meter is also Popularly known as a watt-hour meter. 1 Magnet is called the shunt magnet Ml which is Mounted with a Pressure coil. The Pressure coil is a long coil Made of fine Copper wire that is connected across the Supply single-phase line. Single-phase energy meters are suitable for measuring single-phase AC current flow frequencies of 50/60 Hz, which are used for fixed indoor installation systems.

02. SP MCB:

In single-pole MCB, Switching and protection are Affected in only one Phase. Single phase supply to break the phase only. A single Pole breaker is Typically used with 120-volt Circuits, and a 6-20 amps Miniature Circuit Breaker. They are constructed with one Line Wire and one Neutral wire. A Single Pole switch is the most basic General-Purpose switch that you use to Control a light or another device from one location. These Switches have 2 Brass-Colored screw Terminals Connected to the hot Power source wires. Pole refers to the number of Circuits Controlled by the Switch SP Switches Control only one Switch Electrical Circuit.

Thank You for visiting the website. Keep visiting for more Updates.

Read more Single Phase Wiring

0 Comments

Trackbacks/Pingbacks

  1. Single Phase Wiring – Earth Bondhon - […] Energy Meter Connection […]

Submit a Comment

Your email address will not be published. Required fields are marked *