water Level Indicator for water tank - Simple Electronic Project
Components Needed for this Project:
You can get the components from any of the sites below:
- BC547 Transistor [See Buy Click Amazon]
- 100 Ohm Resistor [See Buy Click Amazon]
- LED 5mm [See Buy Click Amazon]
*Please note: These are affiliate links. I may make a commission if you buy the components through these links. I would appreciate your support in this way!
Related Basic Electronic Mini Project Circuit Diagram:
Frequently asked questions
Make a water level indicator at home. This circuit is soo simple that anyone could easily make one. It can be used along with containers or water tanks of any dimension and can be modified to ring an alarm instead of LEDs.
This circuit diagram to 5 Transistor using water Level indicator Project. Using the 5 LED lights to level test show for DC line control circuit for the low-cost project.
A terminal of all the transistors one by 1 in water and also add the +ve 5v terminal of the battery to the water tank, a current in micro Ampers starts flowing via base terminal.
A Tank water level in the mug or tank rises the other base terminals also get connected to the battery via water and thus other LEDs start glowing.
BC547 is used as a Switch. We have attached resistors of 100 Ohm at the base of transistors Q1, Q2, Q3, Q4 & Q5 to prevent the transistor from being destroyed by high current across the LEDs. When no voltage is applied at the base of transistors.
Introduction content content contentDiagram of Buck-Boost Converter Circuit diagramComponents Needed for this...
Introduction content content contentDiagram of DC Motor Speed Controller Circuit diagramComponents Needed for...
Introduction content content contentDiagram of Over-voltage Protection Circuit diagramComponents Needed for...