Star delta starter wiring plc program:

This Diagram shows the Star delta starter wiring plc program. In this circuit, we use a PLC and a 3-Phase Motor. This circuit diagram is very simple and easy to make. If you want to know more details about this circuit please check our youtube video below the post. Please stay with our website for more updates about electrical electronics and robotics projects gadgets and circuits.

Diagram of Star delta starter wiring plc:

Components needed For this Project:

You can get the components from any of the sites below:

PLC [See Buy Click Amazon]
3 Phase Motor [See Buy Click Amazon]

*Please note: These are affiliate links. I may make a commission if you buy the components through these links. I would appreciate your support in this way!

Read Also:

Components used to make the Star delta starter wiring plc program:

01. PLC:

PLC (PLC) full name Programmable Logic Controller (Programmable Logic Controller). It is a device that can easily control other devices. It is a type of industrial computer control system that will make a decision depending on the custom program and control the output as soon as any signal is received at the input. A PLC usually consists of a microprocessor that has to be programmed by a computer. The program is basically written in computer software and it is loaded to the PLC with the help of a cable.

02. 3-Phase Motor:

A Three-Phase electric motor uses a 3-Phase Power Supply to Convert Electric Energy into Mechanical Energy. It contains four Wires (Three hot Wires and one Neutral Wire) and Uses 3 Alternating Currents of the Same Frequency. Since it Generates a Rotating Magnetic Field, it does not need a Capacitor for the Startup. Some Three-Phase Motors are Reversible, Which Means they can serve as Generators by Turning Mechanical Energy into Electrical Energy.

Thank You for visiting the website. Keep visiting for more Updates.

← Previous Next →

Star delta starter wiring plc program