Mixer grinder wiring connection:

This diagram shows how to make a mixer grinder wiring connection. In this circuit, we use a universal motor, a rotary switch, a 3-pin plug, an indicator light, and an overload relay. This circuit diagram is very simple and easy to make connect it. If you want to know more about this circuit, please check our youtube video below the post.

Diagram of Mixer grinder wiring connection:

Components needed For this Project:

You can get the components from any of the sites below:

single phase Mini Motor[See Buy Click Amazon]
Changeover Switch [See Buy Click Amazon]
Indicator Light 220v AC [See Buy Click Amazon]
Overload switch [See Buy Click Amazon]
3 Pin Plug [See Buy Click Amazon]

*Please note: These are affiliate links. I may make a commission if you buy the components through these links. I would appreciate your support in this way!

Read Also:

Components used to make the Mixer grinder wiring connection:

01. Universal Motor:

A universal motor is a type of electric motor that can be powered by either AC or DC power and uses an electromagnet as its stator to generate a magnetic field. It is a commutated series wound motor, with the stator field coils connected in series with the rotor windings through a commutator. The universal Motor is structurally very similar to a DC series motor but slightly modified to operate with AC power. This type of electric motor is well operated by AC because the field on both sides can be varied in conjunction with the current flowing through the coil and armature.

02. Selector Switch:

Change over switch is a medium of line transfer that is used in industry. Every industry has a supply line using change-over switches to supply power. A Changeover Switch is an Electrical Switch That Allows a load to be Changed from one Electrical Source to Another and vice Versa, Either Manually or Automatically. A Changeover Switch is specially made to transfer a house is electricity from the Normally used Commercial Power supply grid to a more local Generator when a power Outage Occurs.

03. Indicator Light:

An indicator lamp just Sounds Technical, Sometimes it is called a Supervisory light Indicator. Indicator lights are amber in color and can be located at the Front, the Rear, and Sometimes at the Side of the car on both the left And Right-hand sides. The Common colors used by Indicator lamps are red, yellow, blue, white, and green line system. A Panel Indicator Lamp Generally has up to 5 Differently Colored Segments to Indicate Various Conditions on the Machine or Process system.

04. Overload Relay:

An overload relay is a safety device that protects your circuit diagram against damage caused by high-power loads. The relay opens if the load exceeds a certain amount. protecting the circuit from destruction. The simplest version of an overload relay is a single-pole, single-throw (SPST) switch. An overload relay is also referred to as a relay switch. switch is a device that opens the circuit in the event of an electrical, thermal, or power overload system. When mounted with a contactor they create a motor starter connection.

05. 3 Pin Top Plug:

The 3-pin plug tops are used on appliances, extension leads, Light fittings, table fans, etc. The Packaging Comes with Wiring Instructions For the Electrician connection. A transparent cover makes it visually easy to Keep an Eye on the Wiring Connections electrical wire. 3-pin plugs are Designed so That Mains Electricity can be Supplied to Electrical Appliances Safely side. A 3-Pin Plug Consists of 3-pins. Each Pin Must be Correctly Connected to the 3 Wires in the Electrical Cable. Each Wire Has its Own Specified Color so that it can be easily identified power supply.

Thank You for visiting the website. Keep visiting for more Updates.

← Previous

Mixer grinder wiring connection